Fluoride Test Strips, 0-10-25-50-100ppm, Vial of 50 Strips

The Fluoride Test Strips detect Fluoride in steps of 0, 10, 25, 50, and 100ppm. This test strip is used for monitoring fluoride levels in drinking water supplied by city or townships. Too much fluoride present is harmful to humans and animals. The solution to be tested must be at a pH of 0.5 in order for this test to be accurate. This pH measure can be accomplished using concentrated Hydrochloric acid (muriatic acid) to acidify the test solution, and measured with the pH 0-1.5 test strip.

• Flip-Top Vial
• Built-In Desiccant Liner
• Shelf Life: 2 Years

INSTRUCTIONS:

1. Solution to be Tested is Acidified with Hydrochloric Acid (Muriatic Acid). The Resultant pH must be at or below pH 0.5
2. Dip the Test Strip into the pH Adjusted Solution for 1 Second
3. Remove & Wait 10 Seconds Before Comparing Against the Colour Chart
4. The Result Must Be Adjusted to Compensate for the Dilution Used During the Acidification Process

NOTE: The test strip result must be adjusted to compensate for the dilution used during the acidification process.